How to Use a City Trees Disposable Vape Pen (and Fix It)

You have a City Trees disposable and want to know how to use it, or it stopped hitting. City Trees disposables show up on dispensary menus in 2g sizes, and the steps depend on one thing: does your pen have a button? This guide shows you how to tell, how to use each type and what to try when it will not hit.

For fixes that apply to every brand, see our disposable vape not working guide.

Step 1: Check Your Pen and the Insert

City Trees does not publish one set of instructions for every pen, so start with what came in the box. Look for:

  • A button on the side. If there is one, it is a button pen. Skip to the button section below.
  • No button. It is draw activated. You just inhale.
  • A charging port on the bottom. If there is one, the pen is rechargeable. Note whether it is USB-C or micro-USB so you use the right cable.
  • The size on the box. A 2g pen holds more oil and may have a preheat option on the button.

How to Use a City Trees Pen With No Button

  1. Remove all packaging from both ends, including any plug in the mouthpiece or sticker on the bottom.
  2. Take two or three short puffs to prime the coil.
  3. Take a slow, steady draw of three to four seconds. A gentle pull fires the airflow sensor more reliably than a hard one.
  4. Pause about 30 seconds between draws so fresh oil reaches the coil.

How to Use a City Trees Pen With a Button

  1. Remove all packaging.
  2. Turn it on. On most button disposables, five quick presses turns the pen on or off. Check your insert to confirm.
  3. Use preheat if it has one. On many button pens, two quick presses starts preheat. This warms thick oil so it flows. Again, the insert is the final word.
  4. Hold the button while you draw if your insert says to, or just inhale if it fires on its own.
  5. Turn it off with five presses before it goes in a pocket so the button does not fire by accident.

Our guide on how to turn on a disposable vape and use preheat covers common button patterns in more detail.

City Trees Disposable Not Hitting: Fixes to Try

1. Nothing happens

Check again for packaging on the air intake. On a button pen, press five times quickly, because it may be off or locked. Then charge it for at least 30 minutes with a cable and plug you know work.

2. The light blinks

On most disposables, blinking means low battery. Charge it. If it blinks right after a full charge, the pen may have a problem with the heater or a short, and it may be done.

3. Tight draw or a clog

Warm the pen in your hand or pocket for a few minutes. Cold oil thickens and blocks the airway. Then take two or three short dry pulls and one slow draw. On a button pen, run preheat once and try again.

4. Weak hits

Draw slower and longer. On a button pen with heat settings, step up one level. Weak hits on a full charge near the end of the pen usually mean the oil is running low.

5. Burnt taste

Slow down and space out your draws. On a pen with heat settings, drop to the lowest one. If every draw tastes burnt, the oil is likely spent.

6. Oil in the mouthpiece

Wipe the tip with a dry tissue. Hold the pen upright and tap the bottom gently. Do not blow hard into the pen, which can push oil into the battery end.

Keep Your City Trees Pen Working

  • Store it upright, mouthpiece up.
  • Keep it at room temperature, away from hot cars and cold windows.
  • Turn button pens off when you carry them.
  • Recharge before the battery is fully dead.

When to Stop Using It

Stop using any vape that gets hot in your hand, leaks into the battery end, smells like burning plastic or swells. Disposable batteries cannot be repaired.

Need a New Pen Today?

Browse disposable vapes and the full vape menu on MetroBud. MetroBud delivers same-day across Manhattan, Brooklyn, Queens and the Bronx with no delivery fee, you can pay with cash, crypto or card (credit/debit, Apple Pay/Google Pay), and you must be 21+ with a valid ID.

FAQ

How do you use a City Trees disposable vape pen?

Check whether it has a button. With no button, remove the packaging and inhale slowly. With a button, press five times to turn it on, use preheat if it has one, then draw. Your insert has the exact steps.

How do I turn on a City Trees disposable?

If it has a button, five quick presses is the most common on and off pattern for button disposables. Confirm it on your insert. If it has no button, it turns on when you inhale.

Why is my City Trees pen not hitting?

Packaging on the intake, a low battery, a locked button or cold oil are the usual causes. Remove all packaging, charge it, press five times if it has a button and warm it before you draw.

Why is my City Trees disposable blinking?

Blinking usually means low battery. Charge it fully. If it still blinks on a full charge, the pen may be faulty.

Is the City Trees disposable rechargeable?

Check the bottom of your pen. If there is a charging port, it is rechargeable. Use the cable type that fits the port.